Dell OptiPlex 7010 Small Form Factor Desktop Computer - Manual (Page 91)

Steps
1. Using a screwdriver, remove the VGA module cover from the chassis.
NOTE: This step is applicable only when the VGA module is being installed for the first time.
2. Connect the VGA-module cable to the connector (VIDEO) on the system board.
3. Insert the VGA module into the slot on the chassis.
4. Replace the two (M2x5) cross type screws to secure the VGA module to the chassis.
Next steps
1. Install the side cover .
2. Follow the procedure in After working inside your computer .
DP module
Removing the DP module
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the side cover .
About this task
The following image indicates the location of the DP module and provides a visual representation of the removal procedure.
Removing and installing Field Replaceable Units (FRUs) 91