Dell OptiPlex 7010 Small Form Factor Desktop Computer - Manual (Page 79)

Steps
1. Place the processor fan and heat-sink assembly on the system board and align the captive screws to the screw holes on the
system board.
2. Tighten the four captive screws that secure the heat stink to the system board.
3. Connect the processor-fan cable to the connector on the system board.
Next steps
1. Install the disk-drive cage .
2. Install the 3.5-inch hard drive if applicable.
3. Install the 2.5-inch hard drive if applicable.
4. Install the front bezel .
5. Install the side cover .
6. Follow the procedure in After working inside your computer .
Processor
Removing the processor fan and heat-sink assembly
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the side cover .
3. Remove the front bezel .
4. Remove the 2.5-inch hard drive if applicable.
5. Remove the 3.5-inch hard drive if applicable.
6. Remove the disk-drive cage .
7. Remove the processor fan and heat-sink assembly .
Removing and installing Field Replaceable Units (FRUs) 79