Dell OptiPlex 7010 Small Form Factor Desktop Computer - Manual (Page 93)

Steps
1. Using a screwdriver, remove the DP module cover from the chassis.
NOTE: This step is applicable only when the DP module is being installed for the first time.
2. Connect the DP-module cable to the connector (VIDEO) on the system board.
3. Insert the DP module into the slot on the chassis.
4. Replace the two (M3x3) screws to secure the DP module to the chassis.
Next steps
1. Install the side cover .
2. Follow the procedure in After working inside your computer .
HDMI module
Removing the HDMI module
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the side cover .
About this task
The following image indicates the location of the HDMI module and provides a visual representation of the removal procedure.
Removing and installing Field Replaceable Units (FRUs) 93