Dell OptiPlex 7010 Small Form Factor Desktop Computer - Manual (Page 88)

Using a screw driver, push and remove the antenna cover from the chassis.
2. Remove the antenna cover from the screw driver and dispose the antenna cover.
3. Align the pins on the clip with the holes on the system board and press the clip to secure the clip to the system board.
4. Push the antennas into the slots on the back of the chassis.
5. Install the nut and washer to secure the antennas to the chassis.
6. Route the antenna cables through the routing guides on the system board.
7. Press the antenna cable into the clip on the system board.
Next steps
1. Install the wireless card if applicable.
2. Install the disk-drive cage .
3. Install the 3.5-inch hard drive if applicable.
4. Install the 2.5-inch hard drive if applicable.
5. Install the front bezel .
6. Install the side cover .
7. Follow the procedure in After working inside your computer .
Optional Input/Output modules
Serial module
Removing the serial module
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the side cover .
About this task
The following image indicates the location of the serial module and provides a visual representation of the removal procedure.
88 Removing and installing Field Replaceable Units (FRUs)