Dell OptiPlex 7010 Small Form Factor Desktop Computer - Manual (Page 50)

Steps
1. If the optical drive is installed, remove the data and power cables from the routing points on the disk-drive cage.
2. Remove the single (6-32) screw to release the disk-drive cage from the chassis..
3. Lift the disk-drive and detach it from the mounting points on the chassis.
4. Rotate the drive-cage and place it on the chassis.
5. If the optical drive is installed, disconnect the power and data cables from the connectors on the optical drive.
6. Lift the disk-drive cage away from the computer.
Installing the disk-drive cage
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the disk-drive cage and provides a visual representation of the installation
procedure.
50 Removing and installing Customer Replaceable Units (CRUs)