Dell OptiPlex 7010 Small Form Factor Desktop Computer - Manual (Page 95)

Steps
1. Using a screwdriver, remove the HDMI module cover from the chassis.
NOTE: This step is applicable only when the HDMI module is being installed for the first time.
2. Connect the HDMI-module cable to the connector (VIDEO) on the system board.
3. Insert the HDMI module into the slot on the chassis.
4. Replace the two (M3x3) screws that secure the HDMI module to the chassis.
Next steps
1. Install the side cover .
2. Follow the procedure in After working inside your computer .
System board
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the side cover .
3. Remove the front bezel .
4. Remove the 2.5-inch hard drive if applicable.
5. Remove the 3.5-inch hard drive if applicable.
Removing and installing Field Replaceable Units (FRUs) 95