Dell OptiPlex 7010 Small Form Factor Desktop Computer - Manual (Page 86)

4. Install the 2.5-inch hard drive if applicable.
5. Install the front bezel .
6. Install the side cover .
7. Follow the procedure in After working inside your computer .
SMA Antenna
Removing the external SMA antenna kit
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the side cover .
3. Remove the front bezel .
4. Remove the 2.5-inch hard drive if applicable.
5. Remove the 3.5-inch hard drive if applicable.
6. Remove the disk-drive cage .
About this task
The following image indicates the location of the external SMA antenna kit and provides a visual representation of the removal
procedure.
Steps
1. Remove the nut and washer from the two antenna heads.
86 Removing and installing Field Replaceable Units (FRUs)