Interphase Tech iSPAN - Manual (Page 112)

Deleting Channels from Logical Adapters
92 Interphase Corporation
The following table describes channel status parameters.
Deleting Channels from Logical Adapters
To delete a channel from a logical adapter configuration, do
the following:
1. If needed, start the NDIS driver Setup utility, as
described in Starting the NDIS Driver Setup Utility on
page 64 .
Parameter Description
IP
IPX
or
IP+IPX Protocol field. Allows you to select the LAN protocol to
view for the channel: IP, IPX, or the sum of IP and IPX
links.
Cause Displays the internal cause code of the NDIS Driver in
case of channel or outgoing call disconnection.
Protocol Displays the protocol originating the diagnostic code.
Diagnostic Displays the internal protocol diagnostic code. This
code is protocol-dependent.
Ses/Byt Displays the total number of bytes transmitted and
received during the current or last session for this
channel using the selected LAN protocol(s).
Ses/Frm Displays the total number of frames transmitted and
received during the current or last session for this
channel using the selected LAN protocol(s).
Tot/Byt Displays the total number of bytes transmitted and
received since the last system startup for this channel
using the selected LAN protocol(s).
Tot/Frm Displays the total number of frames transmitted and
received since the last system startup for this channel
using the selected LAN protocol(s).