Interphase Tech iSPAN - Manual (Page 204)

Procedures
184 Interphase Corporation
Enable IPX routing First, the RIP for NWLink IPX Service must be
installed in the Windows NT Network Services list.
To enable IPX routing:
1. From the Start menu, select Settings, and then
Control Panel.
2. Double-click the Network icon, and select the
Protocol tab.
3. From the protocols list, select NWLink IPX/SPX
Compatible Transport, and then click
Properties.
4. Select the Routing tab, and select the Enable RIP
Routing option.
NOTE: IPX routing is activated only if different IPX
internal network numbers are assigned between the
two network adapters. For more detailed
information, see the Microsoft networking online
help.
Enable IP routing 1. From the Start menu, select Settings, and then
Control Panel.
2. Double-click the Network icon, and select the
Protocol tab.
3. From the protocols list, select TCP/IP Protocol,
and then click Properties.
4. Select the Routing tab, and enable the Enable IP
Forwarding option.
If you want to... Do this...