Interphase Tech iSPAN - Manual (Page 194)

Watching the Serial Port
174 Interphase Corporation
Watching the Serial Port
SynWatch provides several options for watching the serial
port, which is used to transmit data frames.
To activate frame watching on the serial port, select the port in
the configuration panel. Use the left or right mouse button as
follows to start or change watch activity:
• To start watch activity on an unwatched port, left- or
right-click the checkbox beside the port.
• To change the watch mode of a watched port without
disrupting its watch state, right-click the checkbox
beside the port.
When you select the port, a menu of watch modes appears. The
modes available depend on the installed driver(s) and driver
setup, as follows:
• For the NDIS driver, select PPP Analysis, X.25
Analysis, or Frame Relay .
• For SNA Server Link Services, select SDLC Analysis ,
QLLC , or Frame Relay .
For detailed information about each watch mode, see
SynWatch online help.
N
OTE
If the right mouse button on your mouse is not activated,
use the Watch menu to change watch settings.