Interphase Tech iSPAN - Manual (Page 71)

Chapter 4: Installing the NDIS Software Package
iSPAN Serial WAN Adapter Users Guide 51
6. Click OK.
Completing the Software Installation
After you set up network protocols for the NDIS logical
adapter, the following message informs you that you must shut
down and restart your computer before the settings take effect.
Figure 4-13. Computer Restart Message
Continue as follows:
• If you did not change the network protocol setup, click
Yes to restart the computer.
• If the Windows NT Service Pack is installed and you
did change the network protocol setup, click No. Then
reinstall the Service Pack. Restart the system when
prompted after you complete the Service Pack
installation.