Interphase Tech iSPAN - Manual (Page 149)

Chapter 8: Setting up SNA Server Link Services
iSPAN Serial WAN Adapter Users Guide 129
3. If you want to change the default firmware or hardware
properties of the adapter, click the WAN Setup button
to display the WAN Adapters Setup utility. Then follow
the instructions in
Setting up Firmware and Hardware
on page 145 .
4. In the Frame Relay Network field, select the frame
relay network configuration to be used with the service.
5. If you need to create, edit or remove a network
configuration to be used with the service, do the
following:
a. Click the FR Networks button.
b. On the Frame Relay protocol properties dialog box,
configure the Frame Relay network to use with this
service. For instructions, see
Setting Up Frame
Relay Network Properties on page 155 .
All Frame Relay network configurations created in
this dialog box are available for use by all of the
adapter’s SNA link services and NDIS channels.
c. Click OK to save the Frame Relay protocol
properties and return to the FR Link Service Mode
Settings dialog box.
6. To verify or change the virtual circuit properties used
with the Frame Relay service, do the following:
a. Click the Virtual Circuit button.