Interphase Tech iSPAN - Manual (Page 114)

Manually Disconnecting a Channel
94 Interphase Corporation
To manually disconnect an active channel, do the following:
1. If needed, start the NDIS driver Setup utility, as
described in Starting the NDIS Driver Setup Utility on
page 64 .
2. In the Channels section of the NDIS Driver Setup dialog
box, select the channel and click (Release).
N
OTES
This button is enabled for connected channels only.
If a connected channel contains data traffic, manual
disconnection can cause data loss.
If LAN protocol broadcast frames are enabled, the
channel can immediately reconnect.