Interphase Tech iSPAN - Manual (Page 6)

W
ARNING
■ The network cable(s) must remain disconnected from
the telecommunications system until the card has
been installed in the system.
■ The installation of the card in the host system must be
done in a way that ensures at least 2mm of air gap
between the Printed Circuit Board (PCB) card and any
other components in the host system, so that the
unsafe area remains located only on the card.
Telephone Wiring Warnings
Never install telephone wiring during a lightning storm. Never install
telephone jacks in wet locations unless the jack is specifically designed
for wet locations. Never touch non-isolated telephone wires or terminals
unless the telephone line has been disconnected at the network interface.
Any intervention on the card or in its proximity should be made with the
telephone connector unplugged.
Observe Dangerous Procedure Warnings
Warnings precede potentially dangerous procedures throughout this
manual. Instructions contained in the warnings must be followed. You
should also employ all other safety precautions which you deem
necessary for the operation of the equipment in your operating
environment.
W
ARNING
This equipment generates, uses, and can radiate
electromagnetic energy. It may cause or be susceptible to
electromagnetic interference (EMI) if not installed and
used in a cabinet with adequate EMI protection.