Interphase Tech iSPAN - Manual (Page 92)

Setting Up Logical Adapter Network Properties
72 Interphase Corporation
The Properties dialog box appears for the displayed
logical adapter.
Figure 5-4. NDIS Logical Adapter Properties
3. In the Station Name field, enter the station name for the
logical adapter. (This is an optional property.)
C
AUTION
In the Local Address field, the default Ethernet address is
correct and must not be modified.
4. In the MTU field, enter the MTU (Maximum
Transmission Unit) to be used for communication. If
you are not sure which value to use, leave the default
value.
5. In the Protocols section, select the protocol(s) to be
linked to the adapter. At least one of the protocols is
required.
You can change the protocols only if you started the
NDIS Driver Setup from the Control panel.