Kentrox AI296 User Manual
Page 288
AI296 Version 9.8x User’s Guide
AI296 Commands: diag-eth
9-30
Note: Operating AI296 in the promiscuous mode can reduce performance. The
default setting is disabled promiscuous mode. AI296 automatically returns
to the default setting (promiscuous mode disabled) when the user quits
the
diag-eth
command.
Using the Help Option
To obtain command help:
1. At the prompt, enter
diag-eth
.
2. Enter
help
. The
diag-eth
help screen appears.
Configuring Filters
While using the
diag-eth
command, various filters can be defined to display specific
or general diagnostic information.
Tip: There is help associated with the
filter
command. To view this help, enter
filter
after you enter
diag-eth
. The
filter
help screen appears.
Important: If you are connecting to AI296 using Telnet, remember to filter out the
traffic associated with the telnet connection. Failure to do so can cause
the diagnostic program to become overloaded, which makes AI296
unresponsive.
To configure a filter:
1. At the prompt, enter
diag-eth
.
2. Enter the desired filter. Refer to section
for information on
filter formats.
Capturing Data
While using the
diag-eth
command, data can be captured for Ethernet diagnostics.
All variables and filters can be configured for specific or general information capture.
To configure data capture:
1. Define the following settings:
z
Interpretation Mode
z
Timestamp Mode
z
Promiscuous Mode
z
Data Mode
z
Filters