Liebert 610 - Manual (Page 23)

Operation
17
3.0 O
PERATION
3.1 Display Screen and Operator Controls
Each Liebert Series 610 UPS is equipped with a microprocessor-based Operator Control Panel and
Display Screen designed for convenient and reliable operation. The locations of operator controls are
shown in Figures 3 and 4.
The front location of the control panel enables the user to quickly identify the current status of the
UPS and to perform most of the manual operations. The operator display screen is driven by an easy-
to-follow menu-prompted software program.
Features
The Series 610 interface display system enables the operator to easily perform the following:
• Obtain a quick indication of operational status:
• Is the critical bus OK?
• Is the UPS system OK?
• Is the battery available?
• Is the bypass line available?
• Monitor the power flow through the UPS system and monitor all meter readings:
• Is the critical load being supplied power from the UPS system or bypass?
• Are input, battery and output voltage, frequency and current readings at nominal levels?
• How much battery time is still available during an outage?
• Is the battery recharging after discharge?
• Execute operational procedures:
• Perform critical bus transfer/retransfer between the UPS and the bypass line.
• Start up and shut down the UPS.
• Shut down the system instantly in the event of an emergency.
• Access status reports and history files:
• Obtain a complete listing of the present status of the UPS (input, output and battery voltage,
frequency and current readings and any alarms that may be present).
• Review a complete history report of all events leading up to and immediately after a fault con-
dition.
• Examine an archive listing of all alarm conditions that have occurred over a period of time.
• Make adjustments to programmable parameters (access limited by Security Access function):
• Set the date and the time functions.
• Change the auto-dial phone number and the modem options.
• Select the number of auto-retransfer attempts.
• Make adjustment to the UPS output voltage before performing a manual load transfer.