Liebert 610 - Manual (Page 84)

Operation
78
3.4.5 Battery Exercise Procedures
Once this option has been enabled on the System Options Screen, it appears on the Master Menu. To
initiate a battery testing session, do the following:
1. From the Master Menu, use the Up or Down pads to highlight Battery Exercise. Press the
Select pad to bring up the Battery Exercise screen.
2. Use the Up or Down pads to highlight Start Battery Exercise and press the Select pad to
initiate the Battery Exercise.
3. The UPS rectifier/charger will reduce float charging voltage to 1.9 volts per cell. This forces the
batteries to carry the entire connected load for a short time, but the rectifier remains ready to
carry the load.
4. As the test proceeds, the Test Results screen will record the following items: DC Bus Voltage,
Elapsed Time, DC Current, Load kW and UPS Input Current. The screen will record starting
values, ending values and selected interim values.
5. The test will continue until battery voltage reaches approximately 1.9 volts per cell or until the
test has lasted 30 minutes.
6. Test results will be summarized by one of three statements:
a. Battery Tests OK. The battery was able to support the load as expected.
b. Battery Tests Marginal. Rapid voltage drop, signifying possibly weak cells. Recommend
equalize charging the batteries and repeating the test.
c. Battery Failed Test. Battery was unable to support the load. Call Liebert Global Services
immediately.
Figure 57 Battery exercise control screen (above) and results (below)
CURSOR UP
CURSOR DOWN
CHOOSE
UP :
DOWN :
SELECT :
EXIT
Battery Results
Exercise Results
Start Battery Exercise
Stop Battery Exercise
CURSOR UP
CURSOR DOWN
CHOOSE
UP :
DOWN :
SELECT :
BATTERY EXERCISE 09/02/98 11:17:30
ORDER-000000 SITE ID-00001 SITE TAG-0000001
Battery Temperature 0 C o
DC BUS ELAPSED DC LOAD INPUT
VOLTAGE TIME CURRENT KW CURRENT
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
0 0 0 0 0
00/00/00 00:00:00