Liebert 610 - Manual (Page 43)

Operation
37
Language Selection
English and Portuguese are supported.
System Options
This screen enables and disables optional features which might or might not be installed in your UPS.
The options are Customer Alarm Interface, Battery Exercise, Temperature-Compensated Battery
Charging, Automatic Restart and Continuous Duty Static Switch. LCD contrast and backlight bright-
ness can be set to desired levels. To enable or disable an option, do the following:
1. From the System Configuration screen, press the Up or Down pad to move the highlighted cursor
to System Options.
2. Move to and select option you wish to enable or disable.
3. Press the Up or Down pad to toggle between enabled or disabled.
4. Press the Select pad to set the desired status.
Once enabled, the Customer Alarm Interface and the Battery Exercise options become entries on the
Master Menu and can be controlled from there.
For more information about these options, refer to 3.4.5 - Battery Exercise Procedures and 3.5.5 -
Automatic Restart (Optional).
Figure 25 System options screen
LCD Contrast
Backlight Brightness
Customer Alarm Interface Board................................NO
Battery Temp. Compensated Charging ......................NO
Auto Restart Enabled .................................................NO
Battery Test ..............................................................YES
Continuous Duty Static Switch .................................YES
EXIT
UP: CURSOR UP
DOWN: CURSOR DOWN
SELECT: CHOOSE
SYSTEM OPTIONS