Oki B4100 - Manual (Page 127)

40055101TH Rev.4 127 /
Table 2.9.6 Dial Parameters Settings
No. Item Specifications
Dial parameters
01 Redial tries
02 Redial interval
03 Dial tone detect
04 Busy tone detect
05 MF (TONE) or DP (Pulse)
06 Pulse dial rate
07 Pulse make ratio
08 Pulse dial type
09 MF (Tone) duration
10 PBX line
11 Flash/Earth/Normal
12 Auto start
13 Access digit
14 IT2 detect (FRE only)
Switches on the re-dial times to meet the regulations of the installed
country. 0 to 10 tries (in one-try steps)
1 to 5 tries for FRE.
Switches on the re-dial intervals to meet the regulations of installed
country. 1 to 6 minutes (in one-minute steps)
1 to 12 minutes for FRE.
Selects the dial tone detection.
ON/OFF selectable.
ON: Enable
OFF: Disable
Selects the busy tone detection.
ON/OFF selectable.
ON: Enable
OFF: Disable
Selects dialling by multi-frequency or dial pulse.
Selects the dialling pulse rates for the line.
10 pps/16 pps/20 pps selectable.
Selects pulse dial rate.
33%/39%
Selects pulse dial type.
Normal(N)/10-N/N+1
Selects MF (Tone) duration.
75/85/100 ms selectable.
Selects PBX line.
ON/OFF selectable.
ON: PBX line
OFF: PSTN
Selects the PBX type to meet the exchange requirements.
NORMAL/EARTH/FLASH selectable.
(PBX line origination types)
Enables or disables the function of dialing without pressing the
START key in one-touch dial and 2-digit auto dial modes.
ON: Enable
OFF: Disable
Prefix dialing digits with which PBX connects the fax to the public
line.
OFF/max. 4digit(s) selectable.
Digit: Enable
OFF: Disable
Selects 2nd dial tone detection ON/OFF selectable. (FRE only)
ON: Enable
OFF: Disable
Rev. 2