Oki B4100 - Manual (Page 625)

40055101TH Rev.4 625 /
5) When the setting is correct, enter [Y]. The system is now registered. If not correct, enter [N]. Then repeat
from step 1) again.
When registering the system, also register ANSI.SYS required for screen control and MOUSE.SYS for using
the mouse.
If RMCS is already set in the IBM PC/AT, RMCS SETTING MENU is displayed as below.
6) When updating, enter [Y]. Then updating status. When not updating, enter [N].
<< RMCS SETTING >>
Remote Management Center System
Press the Esc key to cancel.
HARD DISK DRIVE = [C]
DIRECTORY = [C:\RMCS_ ]
PASSWORD = [ ]
DIPSW (ON:0 OFF:1) = [11000000]
Are you sure (Y or N)? Y
<< RMCS SETTING >>
Remote Management Center System
Press the Esc key to cancel.
"RMCS" system already registered!
Over write OK ? Y