Oki B4100 - Manual (Page 609)

40055101TH Rev.4 609 /
2
1
3
8
9
C
B
A
0
6
7
4 Hopping Roller Shaft Assy 5
3.3.2 TQSB2-PCB
(1) Remove the pulse motor (see 3.3.1).
(2) Remove the connector O from the TQSB-2PCB P.
(3) Remove the screw Q and remove the TQSB-2PCB P.
Note : Refer to Detall A in the previous page.
3.3.3 Hopping Roller Shaft Assy and One-way Clutch Gear
(1) Follow up to step (3) of 3.3.1 and remove the hopping frame assy.
(2) Remove the screw 1 and remove the earth plate 2. Remove the sensor lever 7 and remove the ground
plate 6. Remove the gear 3 and remove the metal bush 5 and Hopping Roller shaft Assy 4.
(3) Remove the E-ring A and remove the one-way clutch gear B on the right side of the feed roller 0.
Note : The metal bush C also comes off. Be careful not to lose it.