Oki B4100 - Manual (Page 624)

40055101TH Rev.4 624 /
2) Enter the directory name with up to eight alphanumeric characters.
3) Register a password of up to 15 alphanumeric characters excluding [\],[“]. If the system oprator is not
defined, password registration not required.
4) When you use RMCS Model 10, set the dip switches on the RMCS card. Normally, you need only press
[Enter]. When an other extention slot and conflicting address space are being used, change the address
space with the dip switches, then set the contents by using 1 and 0.
When you use RMCS Model 20, you need only press [Enter].
OFF corresponds to 1 and ON to 0. Therefore set the dip switches to 11000000 in the following case.
<< RMCS SETTING >>
Remote Management Center System
Press the Esc key to cancel.
HARD DISK DRIVE = [C]
DIRECTORY = [C:\RMCS ]
PASSWORD = [_ ]
<< RMCS SETTING >>
Remote Management Center System
Press the Esc key to cancel.
HARD DISK DRIVE = [C]
DIRECTORY = [C: RMCS ]
PASSWORD = [ ]
DIPSW (ON:0 OFF:1) = [11000000]
(For RMCS Model 10 only)