Oki B4100 User Manual
Page 603
40055101TH Rev.4
603 /
3.
PARTS REPLACEMENT
This section covers the procedures for the disassembly, reassembly and installations in the field.
This section describes the disassembly procedures, and for reassembly procedures, basically proceed with the
disassembly procedures in the reverse order.
3.1
Precautions Concerning Parts Replacement
(1)
Parts replacements must be carried out, by first turning the facsimile power switch off “O” and removing
the facsimile from the Second Paper Feeder.
(2)
Do not disassemble the Second Paper Feeder if it is operating normally.
(3)
Establish the extent of disassembly suitable for the purpose of the procedure, and do not disassemble any
more than necessary.
(4)
Only specified service tools may be used.
(5)
Disassembly must be carried out according to the prescribed procedures. Parts may be damaged if such
procedures are not followed.
(6)
Small parts such as screws and collars can easily be lost, therefore these parts should be temporarily fixed
in the original location.
(7)
When handling printed circuit boards, do not use any glove which may generate static electricity.
(8)
Do not place the printed circuit boards directly on the equipment or floor.