Oki B4100 - Manual (Page 24)

40055101TH Rev.4 24 /
28 Error correction
29 Communication mode
30 Ringing signal detection sensitivity
1) Voltage range
2) Frequency range
3) Ring response time
31 Image memory
32 Telephone handset
(option)
Rev.2
Table 1.5.1 (8/10) Basic Performance Specifications
No. Item Specifications
OKIOFFICE44/OKIFAX 4100
OKIFAX 5200/5300
OKIFAX 5500/5600
Basic model
256K-byte
256K-byte
512K-byte
Optional memory
1M-byte
1M-byte
1M-byte/2M-byte
Memory
condition
OKIFAX 4100
OKIOFFICE44
[pages]
OKIFAX
5200/5300
[pages]
OKIFAX
5500/5600
A4 Setting
[pages]
Standard
(without option)
With
option
board 1M-byte
2M-byte
20
100
20
100 120
200
* 1 CTR board is not mounted.
* 2 CTR board is mounted.
5500: 30* 1
5500: 26* 2
5600: 38
Rev.2
27 Transmission time 3 sec.(approx 3.5 sec) /ITU-T No. 1 sample document
(OKIFAX 5500/5600)
6 sec.(approx 6.9 sec) /ITU-T No. 1 sample document
(OKIOFFICE44, OKIFAX 4100/5000 series)
Note: This is Phase C time at 3.85 line/mm and 28800 bps for 3
sec. and 14400 bps for 6 sec. in MMR code transmission.
ITU-T Error correction mode (ECM)
Oki Data ITU-T ECM
Half-duplex
25 to 150 V r.m.s.
Inoperative below 10 V
20 to 68 Hz
One-ringing signal or 5 to 30 seconds.
(Selectable in 5 sec. steps. F + OT9 +
←
+ 11)
Note: ITU-T No.1 sample document is used to count the num-
ber of sheets.
Back-up time on electrical interruption:
Min. one hour (OKIFAX 5000 series with option memory)
Note: OKIOFFICE44/OKIFAX 4100 and OKIFAX 5000 se-
ries without option memory does not back up the message
received in memory for the power failure.
General telephone function is available while the power is on.
Note: In the fax special versions, general telephone is available
even when the power is off.