Oki B4100 - Manual (Page 234)

40055101TH Rev.4 234 /
Table 6.15.1 (2/2) Service Code List
Code Description
39C1 DECODER hardware error. (cannot detect end of picture)
41A0 There was no response each time in response to the three post commands.
41A6 Received signal other than the desired signal in responce to the post command.
41A9 Fall back in Phase C is not possible.
41C8 T5 time out.
41CE Received negative signal in response to the post command.
41E0 Control chanel data. Time out in Phase D.
49CC Received signal other than the desired signal in response to RNR.
49CD Command not received in response to RNR.
49E0 Data time out of
49E1 Fall back in Phase C is not possible.
60A0 Broadcast completed.
6803 DCN received in response to NSF/DIS without sending a single picture.
9080 Pressed STOP key.
9081 T1 time out.
9082 T2 time out.
9083 T3 time out.
9084 No recording paper.
9087 Document jam.
9088 60-minute or 70-minute time out.
9089 Document length has exceeded its maximum limit.
908E Recording paper jam.
9090 Received DCN.
90B1 Picture memory hash error.
90C1 Document removed prior to transmission.
90C6 Normal or error-free lines not received for 13 seconds.
90C7 Error frame protocol received.
90D4 Hardware error in transmission system. (response of modem not detected)
90D5 ENCODER error. (Picture storage fault)
90F0 Option (2'nd tray) error.
90F1 Fan motor error.
90F2 Fuser error.
90F3 Recording paper size error.
90F4 Cover open.