Oki B4100 - Manual (Page 629)

40055101TH Rev.4 629 /
2.2.5 UPdating the Dip Switches
This setting is available for only RMCS Model 10.
1) Search the directory in which the system is registered. When the system is foud, the dip switch setting is
displayed.
For the detail of setting, refer to 2.2.1.
After setting is completed, press [Enter]. Then the screen for verification is displayed.
3) When the setting is corrected, enter [Y]. The dip switches are now updated. If not correct, enter [N]. Then
repeat from step 1) again.
<< DIP SW UPDATE >>
Remote Management Center System
Press the Esc key to cancel.
DIP SW (ON:0 OFF:1) = [11010000]
(For RMCS Model 10 only.)
<< DIP SW UPDATE >>
Remote Management Center System
Press the Esc key to cancel.
DIP SW (ON:0 OFF:1) = [11010000]
Are you sure (Y or N)? Y