PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 106)

Appendix B---PowerWalker-WinPower Event Table
Serial
Number Event Description Type of
Message
Remarks
1 UPS Battery Low
Serious Can be set as no shutdown system
through “Shutdown parameter”
2
UPS Battery Time
Exhaust Serious Can set battery backup time through
“Shutdown parameter”
3 UPS Fail
Serious
4 UPS Output Overload
Serious
Output load is more than 110%
6 Communication Lost
Warning The connection of communication
cable is not good, or communication
port fault.
7 AC Fail
Warning
8 On Bypass
Warning UPS will be switched to bypass mode
for the reason of overload, hardware
fault and so on. Online UPS is also in
bypass mode when it is off, at this
time UPS has no protection function.
9 Bypass without output
10 Self-test Fail
Warning
11
Phase sequence incorrect
in Bypass
Warning
Three-phase UPS support
12
Battery switch not
engaged Warning
Three-phase UPS support
13 Load unbalance
Warning
Three-phase UPS support
14 Load too high
Warning
15 Internal warning
Warning
Three-phase UPS support
16 Maintain cover is open
Warning
17 AC Restore
Information
.
18 Communication Create
Information
.
19 Agent Start
Information
.
20 Agent Stop
Information
.
21 System be shutdown
Information
.
22
System be Shut down by
Other Agent
Information
Set the Agent need to be in response
to through “Shutdown parameter”.
23 Special date Close UPS
Information
.
24 Weekly Close UPS
Information
.
25 Self-test Start
Information
Self-test begins immediately.
26 Self-test cancel
Information
.
27 Self-test End
Information
.