PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 51)

51
Diagram 3-2-26
Note: If the OK button is disabled, the current Agent is read-only, and you cannot set up the
parameters. Select “Act as Administrator” from the “System” menu to log in as a Super user.
27) "Add Area" Dialog
To open the Add Area window, select “Add Area” from the “SNMP” menu.
You can add areas and relative information. The new areas are displayed below the SNMP node
in the left tree view. Refer to the following diagram 3-2-27.
Diagram 3-2-27
Note: You must select the SNMP node at the left tree view. If the OK button is disabled, the
current Agent is read only, and you cannot perform this task. Select “Act as Administrator” from the
“System” menu to log in as a Super user.
28) "Modify Area" Dialog
Note: If the OK button is disabled, the current Agent is read-only, and you cannot set up the
parameters. Select “Act as Administrator” from the “System” menu to log in as a Super user.
Select “Modify Area” from the “SNMP” menu.
You can modify the appointed area information. Refer to the following diagram 3-2-28.
Diagram 3-2-28