PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 12)

12
Diagram 2-3-10
If the software is installed successfully, PowerWalker-WinPower application can be found in the
Start menu\Programs\. Refer to the following diagram 2-3-11.
Diagram 2-3-11
For console mode:
1. Enter the directory according the system, run setup.bin or setup_console.bin to start the
installation program.
Note: For UnixWare platform, make sure JRE has been installed in your system,
then enter the /GenericUnix directory to start the setup.
2. Read the information provided, press ENTER to continue the installation.
3. When the installation program is completed, click “Done”.
4. Reboot the Linux and UNIX system after installation.
The installation will set environment variables for PowerWalker-WinPower in /etc/profile file. (For
details to see 'Set environment variable' below). Reboot the system in order to make the setting valid.
4. Start/Stop PowerWalker-WinPower
In Windows operating system
Start Agent:
Run the PowerWalker-WinPower from Start\Program\PowerWalker-WinPower will start the
TrayIcon and Agent. For windows7 operating system, you should restart computer after the first
installation.
Refer to the Diagram 2-4-1 as below.