PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 7)

7
Chapter 2 PowerWalker-WinPower Installation, Start & Uninstall
1. System Requirements
128 MB physical memory at least (256MB is recommended)
160 MB hard disk space at least
More than 256 colors and 800 * 600 resolutions or above display is recommended
The user is required to have the right as system administrator
On Linux or UNIX operating system, user must log in system with
“root” account to carry
out the installation. After installation finished, system need to be reboot
TCP/IP protocol must be installed to support network management
An available communication port (RS-232 Serial Port or USB port) is needed while
connecting to device with a special communication cable.
2. Platforms supported by PowerWalker-WinPower include the following
Windows 98
Windows me
Windows 2000
Windows 2003
Windows 2008
Windows 2008 server core
Windows XP
Windows vista
Windows 7
Windows 8
Windows SBS 2011
Windows server 2012
Linux
Solaris/Sparc 2.6, 7, 8, 9,10
Solaris/Intel 2.6, 7, 8, 9 ,10
HP-UX 11.x, 11i.x (PARISC CPU)
AIX 4.3.3, 5.1, 5.2 , 5.3
Mac OS X
Compaq Tru64 Alpha
SCO UnixWare 7.1.1, 7.1.3
SCO Unix 8.0
FreeBSD x86
SGI Irix 6.5.x
VMware ESX 3.5, 4.0, 4.1
VMware ESXi 4.0, 4.1, 5.0, 5.1, 5.5
XenServer 5.5
Note: Telecom power only supports the windows platforms.
3. PowerWalker-WinPower Installation Steps
Note: The installation must be started with “root” account in Linux and UNIX systems! And
after installation you must restart the system!
Enter the right directory of the CD according the system platform type.
For GUI mode:
Insert the PowerWalker-WinPower CD, find out the operate system of your computer in the CD
directory, Refer to Diagram 2-3-1 as below.