PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 36)

36
Diagram 3-2-11
The function is only for UPS.
The function can be used to display and setup UPS self-test task. UPS self-test task has two types:
“once” and “monthly”.
UPS self-test type: UPS self-test for 10 seconds, UPS self-test to battery low, and UPS self-test
for the appointed time. The appointed time range is 1 to 99 minutes, and the default value is 10
minutes.
The “UPS Test Manager” dialog contains two parts: task list and calendar. All the UPS self-test
and UPS on/off tasks are shown in the calendar. The red dot denotes the Power Off action, the
green dot denotes the Power On action and the blue dot denotes the self-test action. Click the “Add
Test” button and users can setup the special time and monthly UPS self-test task in the popped up
dialog. The self-test task added will be shown in the schedule.
If you select one of the UPS self-test tasks in the list, you can modify the task that has been set
by clicking the “Modify” button. If you select one of the UPS self-test tasks, you also can remove the
task by clicking “Remove” button.
Note: If the “OK”, “Add Test”, “Modify” and “Remove” buttons are invalid, it means that
your access right to the current Agent is “read only” and you can’t carry out the setting. You
should log in as a super user.
12) "UPS On/Off Manager" Dialog
The “UPS On/Off Manager” dialog can be opened from the “UPS On/Off Schedule” item of
“Device” menu. Refer to the following diagram 3-2-12.