PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 76)

76
Diagram 4-10-1
Below is the use remark of SMS Setting, refer to the diagram 4-10-1.
1. Sender: SMS is sent through GSM modem or mobile phone connected with your computer.
User should select COM port used by GSM Modem or mobile phone, and set baud Rate of this COM
port.
2. Receiver: the mobile phones numbers that can receive the SMS. It can be one or more. If the
event occurs, the software will send the short message to all the phone numbers in the "Receiver"
list.
3. Send message: Use can select the event that need to be informed by SMS.
Another method to select event code:
Select one of the events (for example: AC Fail) from the “Event List”, that is on the left side of the
“Event Action”; and then select “Send SMS” on the right side, finally select the “OK” button to save
and exit.