PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 52)

52
29) "SNMP Trap Receiving Port Setting" Dialog
To open the SNMP Port Setting window, select “SNMP Trap Receiving Port Setting” from the
“SNMP” menu.
You can change the SNMP Port if the default Port 162 is occupied by other programs. The range
of the new SNMP Port is 1 to 65535. Refer to the following diagram 3-2-29.
Diagram 3-2-29
Note: You must select the SNMP node at the left tree view. If the OK button is disabled, the
current Agent is read only, and you cannot perform this task. Select “Act as Administrator” from the
“System” menu to log in as a Super user.
30) "SNMP Event Log" Dialog
The Event Log Viewer displays the UPS SNMP event history.
You can view the Event Log by select “Event Log” from the “SNMP” menu.
You can set the length of the event log file by select the “Event Log Setting” from the “SNMP”
Menu.
To delete all data, click Clear All.
Click Close to exit the window. Refer to the following diagram 3-2-30.