PowerWalker WinPower Software V.4.3.0.1 Manual User Manual
Page 83
83
If the Remote Control Permission Switch is on, then you can monitor and control this device. So
after you login as a super user, you can control all of the operation, Refer to the following diagram 4-
12-6.
Diagram 4-12-6
13. How to realize the Remote Control of any one of the device in Internet
Precondition
The computers with PowerWalker-WinPower must setup TCP/IP protocol in the
communication protocol.
The computer with PowerWalker-WinPower has been connected to the Internet.
Steps for realization
Keep the communication smooth:
test with network command “PING” under command
prompt window. For example, a computer named ssc-test in internet, whose
corresponding IP address is 202.103.190.87, and then you can finish the test with
command “ping 202.103.190.87”. Refer to the following Diagram 4-13-1, which
indicates that the physical link of Internet is smooth.