PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 50)

50
25) "Search Device" Dialog
Note: If the Search button is disabled, the current Agent is read-only, and you cannot set up the
parameters. Select “Act as Administrator” from the “System” menu to log in as super user.
To add devices:
1. Click the “Search Device” item from the” SNMP” menu.
2. Select which TCP/IP protocol that SNMP support in the Search Device dialog, protocol IPv4 or
IPv6.
For IPv4, both single device and segment device searches are supported. Enter an IPv4 address
in the Start IP field and the End IP field.
For IPv6, user can enter only one IPv6 address other than IP ranges to search. If IPv6 address is
broadcast IP (default IPv6 address is broadcast IP ff02::1), all Network Management Card that
support protocol IPv6 within LAN will be found.
3. Click “Search” button. After searching, the new device displays in the tree view.
4. Double-click the new device node to connect it with the Internet browser of the Network
Management Card. The Link column indicates successful communication. Refer to the following
diagram 3-2-25.
Diagram 3-2-25
26) Modify SNMP Device
Select Modify Device from the “SNMP” menu. You can modify the SNMP device information,
including: Name, Area, and Community (The default value is “public”).
Refer to the following diagram 3-2-26