PowerWalker WinPower Software V.4.3.0.1 Manual User Manual
Page 75
75
Diagram 4-9-2
Enter the Email Address in the “Add Receiver Email Address” dialog, and select “OK” button to
save and exit.
Completing event setting: select one of the events (For example, UPS battery low) from the “Send
message”; and then select the user that has been set in the “Receiver Email Address” list, finally
select the “OK” button to save and exit.
10. How to realize sending event messages by mobile phone
Precondition
The precondition of sending messages by mobile phone is that the computers with PowerWalker-
WinPower must have at least one communication port used to be connected to GSM Modem or
mobile phone.
Steps
Configure “SMS”: click the “SMS setting” item of the “Tools” menu, and will pop up the “SMS
Setting” dialog. Refer to the following diagram 4-10-1.