PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 41)

41
The “Receiver E-Mail Address” list box lists the email addresses. Click "Add" button to add an
email address item. Select an address item and click "Remove" button will delete the item. Selected
an email address item, and click the "Test" button will send a test email to the email address.
The "UPS message", “Telecom Power System message” and “ATS message list” list boxes list all
the message, you can select the message by click the check box with the message item.
All of the SMTP parameter’s default value is vacancy, and it can be setup in the local Agent only.
To send email to the appointed user, the SMTP server name or IP address must be set, or the email
will not be sent successfully.
Note: If you want to send email via Internet, you must have a SMTP account in the Internet.
If the “OK” button is invalid, it means that your access right to the current Agent is “read
only”, and you can’t carry out the parameter setting. You should log in as a super user.
16) "SMS Setting" Dialog
The “SMS Setting” dialog can be opened from the “SMS Setting” item of “Tools” menu or click
Send SMS “Setting” button in “Event Action” Dialog. Refer to the following diagram 3-2-16.
Diagram 3-2-16