PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 68)

68
Diagram 4-5-1
Remote Shutdown by Agent:
Click the “Add” button in the ”Shutdown Options”, enter IP address of agent in the popped up
dialog, and click the “OK” button to finish the setting. When the Agent received the specified agent's
shutdown signal, system will be shut down in delay time.
Shutdown Remote Agents:
Click the “Add” button in the ”Shutdown Remote Agents”, configure the shutdown conditions, enter
IP address of agent in the popped up dialog, and click the “OK” button to finish the setting. When
shutdown condition is touched off, agent will send shutdown signal to the appointed remote Agents.
6. How to realize Setting up shutdown parameter
The function is only for UPS.
Click the “Shutdown Parameter” item of the “Device” menu, and will pop up “Shutdown Settings”
dialog. Refer to the following diagram 4-6-1.