GE Industrial Solutions MX350 Instruction manual - Manual (Page 19)

CHAPTER 2: INSTALLATION MECHANICAL INSTALLATION
MX350 AUTOMATIC TRANSFER CONTROL SYSTEM – INSTRUCTION MANUAL 2–3
Figure 3: Panel mounting and cutout dimensions
The DIN rail mounting is illustrated below. The DIN rail conforms to EN 50022.
CAUTION
CAUTION:
To avoid the potential for personal injury due to fire hazards, ensure the unit is
mounted in a safe location and/or within an appropriate enclosure.
Figure 4: DIN rail mounting
The screw mount for high vibration environments is illustrated below.
#4 - 40x3/8in SELF-TAP PAN HD PHILIPS
QTY: 6 (SUPPLIED); GE PART NO. 1402-0017
TIGHTENING TORQUE: 8 lb-in
REAR OF PANEL
CUTOUT AND
MOUNTING HOLES
INSTALL RELAY
FROM FRONT
OF THE PANEL
3.775”
(95,89 mm)
5.580”
(141,73 mm)
0.105”
(2,67 mm)
0.138”
(3,49 mm)
3.500”
(88,90 mm)
0.130”
(3,30 mm) (QTY: 6)
5.790”
(147,07 mm)
1.750”
(44,45 mm)
889725A1.CDR
SNAP-IN THE DIN CLIPS (QTY: 4)
FOR DIN RAIL MOUNTING
0.30”
(7,6 mm)
1.38”
(35,1 mm)
DIN 3 RAIL
889726A1.CDR