Upgrading setpoint files to a new revision – GE Industrial Solutions MX350 Instruction manual User Manual
Page 56
3–26
MX350 AUTOMATIC TRANSFER CONTROL SYSTEM – INSTRUCTION MANUAL
ENERVISTA™ MX350 SETUP SOFTWARE
CHAPTER 3: INTERFACING WITH THE MX350 AT CONTROLLER
1.
In the File pane, right click on File and select the New Setpoints File item. The
following box will appear, allowing for the configuration of the setpoints file for the
correct firmware version. It is important to define the correct firmware version to
ensure that setpoints not available in a particular version are not downloaded into the
relay.
2.
Select the Firmware Version, and Order Code options for the new setpoints file.
3.
For future reference, enter some useful information in the Description box to facilitate
the identification of the device and the purpose of the file.
4.
To select a file name and path for the new file, click the button beside the File Name
box.
5.
Select the file name and path to store the file, or select any displayed file name to
replace an existing file. All MX350 setpoints files should have the extension ‘M30’ (for
example, ‘ExerciserStatus.M30’).
6.
Click OK to complete the process. Once this step is completed, the new file, with a
complete path, will be added to the EnerVista™ MX350 Setup software environment.
Upgrading setpoint
files to a new revision
It is often necessary to upgrade the revision for a previously saved setpoint file after the
firmware has been upgraded. This is illustrated in the following procedure:
1.
Establish communications with the relay.
2.
Select the Online > Device Setup menu item and record the Firmware Revision from
the Device Setup window.
3.
Load the setpoint file to be upgraded into the EnerVista SR3 Setup environment as
described in the section, Adding Setpoints Files to the Environment.
4.
In the File pane, right-click on the saved setpoint file.
5.
Note the File Version of the setpoint file. If this version is different from the Firmware
Revision noted in step 2, select a New File Version that matches the Firmware Revision
from the pull-down menu.