GE Industrial Solutions MX350 Instruction manual - Manual (Page 87)

CHAPTER 5: SETPOINTS CONFIGURATION SETPOINTS
MX350 AUTOMATIC TRANSFER CONTROL SYSTEM – INSTRUCTION MANUAL 5–13
Screensaver The user can select whether or nor the screen save mode is enabled or disabled. When
enabled, the screen will change to displaying a picture of the controller after being idle for
one minute. After two minutes, the pictures will disappear and the screen will go
completely dark.
The Screensaver is enabled by default. If desired, the user can disable it in order to have
the screen visible at all times. GE discourages disabling the Screensaver in order to avoid
the screen being burned-in with a screen image.
Events
The Events screen allows the user to enable or disable certain functions relating the
recording of events as seen in the picture below.
Figure 9: Events screen
The event recorder can be enabled to record alarm, fault, and/or control events. It can
also be used to record changes made to the real time clock of the controller.
Zenith
The Zenith screen gives an overview of the factory setup of the MX350 controller.
Parameters on this screen are not accessible to the user. Only Zenith authorized personnel
can make changes to this screen.
DANGER
DANGER: Unauthorized changes made to this screen can lead to damage or destruction of the
ATS and can result in personal injuries or death!