GE Industrial Solutions MX350 Instruction manual - Manual (Page 49)

CHAPTER 3: INTERFACING WITH THE MX350 AT CONTROLLER ENERVISTA™ MX350 SETUP SOFTWARE
MX350 AUTOMATIC TRANSFER CONTROL SYSTEM – INSTRUCTION MANUAL 3–19
6. After the uninstall, remove the USB cable from the Device’s native USB port, wait for at
least 10 Seconds and reconnect it.
7. Now the ‘Found New Hardware Wizard’ will open, select No, not this time and press
the Next button.
8. Select Install the software automatically (Recommended) and press the Next
button.