GE Industrial Solutions MX350 Instruction manual User Manual
Page 21
Advertising
CHAPTER 2: INSTALLATION
MECHANICAL INSTALLATION
MX350 AUTOMATIC TRANSFER CONTROL SYSTEM – INSTRUCTION MANUAL
2–5
Figure 6: Removing a module from the MX350
Use the following procedure to insert a module.
1.
Ensure that control power has been removed from the MX350.
2.
Ensure that the module is being inserted into the correct slot.
3.
Align the module card edges with the slot track as shown in the diagram below.
4.
Gently slide the modules into the slot until the modules latch into the opening marked
by the two arrows on top of the MX350 case.
5.
Attach the two captive screws to anchor the module to the case (use a tightening
torque of 3.5 lb.-in.).
Figure 7: Inserting modules into the MX350
889733A1.CDR
889734A1.CDR
Advertising