GE Industrial Solutions GPS2436 - Manual (Page 13)

Galaxy Power System GPS2436
Issue 1 August 2012 13
3 Galaxy Millennium II Controller
Overview
Introduction
The GPS2436 comes equipped with the Galaxy Millennium II Controller. This
section describes the controller operation and general information about the
features of the front panel keys, LEDs, and display.
The Galaxy Millennium II Controller provides advanced local and remote
monitoring and data acquisition features. The controller monitors system
parameters; such as, system voltage and current, and components; such as
rectifiers, and distribution circuits. The controller reports the status and issues
appropriate alarms in the event a failure occurs.
Each cabinet is equipped with a bay interface card (BIC). The BIC acts as an
interface to the cabinet control and alarm signals.
User Interface
and Display
The Millennium II’s primary user interface is a backlit LCD front panel display
that can be viewed in English or Spanish, two rows of LEDs, an array of
pushbutton keys, and a pair of test jacks.
Figure 4-1 illustrates the front panel.
Default Display
The default display shows basic system status; system voltage, load current,
and plant state. The controller returns to this display approximately three
minutes after a key is pressed. The information on the screen is updated
automatically approximately every two seconds.