GE Industrial Solutions Millennium II Controller J85501P-1 User Manual
Page 26
Basic Installation and User’s Guide for the Millennium II Controller
Issue 3 January 2008
26
Gateway (LAN) Connections
Step Action
NOTE: The Gateway card has been designed into the MCR1/MCR2 boards and
requires no additional circuit packs.
NOTE: The Gateway has an IEEE 802.3 compliant 10Base-T network interface.
Since the cable length required to connect to the network is variable, this
cable must be supplied by the user.
1.
At the controller, connect one end of the network interface cable to P2. This
connector is located at the bottom center of the MCR1 board, and
immediately below the MCR2 board.
2.
Connect the other end to an IEEE 802.3 compatible network.
3.
Configure the Gateway for the network by contacting the customer’s
network administrator. Detailed configuration information may be found in
the User’s Guide for Millennium II Controller Advanced Features manual.
Rectifier Cabling
Step Action
NOTE: For new installations, the Millennium II rectifier cabling has been factory
wired and installed to the cabinet BIC/BLJ board for alarm and rectifier
communication.
NOTE: For connector integrity, verify that the cable is installed and connected
properly.
1.
Verify that the rectifier cable is connected to P9, and NOT P7(AUX) cable
connector.
2.
Verify that the cable connector is properly seated into P9, and that it is not
loose.
3.
Verify that the rectifier cable terminating on the BIC/BLJ board is connected
to P9 and also not loose.
Remote Peripheral Monitoring (RPM)
RPM provides data acquisition capability far beyond that normally available in a power
system controller. Monitoring modules available consist of:
• Shunt monitors (6 channels + 1 temperature channel)
• 0-100mV dc Voltage monitors (6 channels + 1 temperature channel)
• 0-3V dc Voltage monitors (6 channels + 1 temperature channel)
• 0-16V dc Voltage monitors (6 channels + 1 temperature channel)
• 0-200V dc Voltage monitors (6 channels + 1 temperature channel)
• Temperature monitor (7 Channels)
• Control Relay module (3 sets of programmable form C relay outputs)