GE Industrial Solutions Millennium II Controller J85501P-1 User Manual
Page 83
Advertising
Basic Installation and User’s Guide for the Millennium II Controller
Issue 3 January 2008
83
6.
Rectifier Float Setpoints
Enter the float setpoint by selecting the following menus from the front panel display:
Plant V
I limit
SHVSD
7.
Connect Serial Rectifier Cable
The RJ45 connector is located at top of the MCR1 board and is labeled
P9.
(see Figure 6-6)
Step Action
a.
Locate P9 (Not to be confused with P7-Aux)
b.
Using the existing serial cable, connect to P9.
Advertising