GE Industrial Solutions Millennium II Controller J85501P-1 User Manual
Page 69
Basic Installation and User’s Guide for the Millennium II Controller
Issue 3 January 2008
69
4.
Alarm Threshold Settings
Alarm thresholds are designed to generate low/high voltage alarms.
Record the Float Alarm Thresholds by selecting the following menus from the
front panel display: MENU ÆCONFIGÆ ALARM THRESHOLDS
Alarm Float
Boost
(optional)
High Voltage
High Float Voltage
Battery on Discharge
Rectifier On
Very Low Voltage
5.
Plant Shunt
Shunt information should be recorded, so that it can be programmed when the
new controller has been installed.
Record this information by selecting the following menus from the front panel
display: MENUÆ CONFIGÆ PLANT
Shunt I
Shunt mV
Shunt Type
6.
Low Voltage Disconnects
Low voltage disconnect information, if installed in the system, should be
recorded, so that it can be programmed when the new controller has been
installed.
Record this information by selecting the following menus from the front panel
display: MENUÆ CONFIGÆ LOW VOLTAGE DISCONNECT
Note: Contactor State cannot be changed by the user.
Contactor 1
Type
Disconnect
Reconnect
Contactor 2
Type
Disconnect
Reconnect
Contactor 3
Type