GE Industrial Solutions Millennium II Controller J85501P-1 - Manual (Page 94)

Basic Installation and User’s Guide for the Millennium II Controller
Issue 3 January 2008 94
9. Remove Millennium Controller from the Cabinet Door
With all connectors and wires removed from the Millennium circuit
packs:
• Make sure that they have been removed from the Millennium
housing.
• If other wires or cables are connected to the Millennium, then
Mark, Tag, Insulate and remove them.
With two people, one supporting the controller, remove all 6,6-32
nuts (3 on left side and 3 on right side). Slowly remove the
controller unit from the cabinet door.
THIS COMPLETES THE CONTROLLER REMOVAL SECTION
Installing the Millennium II Controller
Figure 6-11: Millennium II Controller Connections
Step Action
1. Mount the Millennium II Controller
With two people, one supporting the controller, position the
Millennium II controller housing over the six standoffs (3 on left
side and 3 on right side). Using 6, 6-32 nuts, secure the controller
housing to the cabinet door. (Torque to 10 in-lbs, or 1.1 N-m)