Alpha Technologies Cordex Controller Ver.3.1x - Manual (Page 94)

0700015-J0 Rev B 92
6.9.8 Configuring the Point to Point Protocol (PPP) Connection Device
The Supervisor can set the baud rate and the CXC rear port device (Internal / External / NULL modem).
For more information on PPP, refer to section 9.2.
LCD Interface
See 8.3 for modem compatibility. See
Table L for factory defaults (baud rate
and initialize string). Modem baud rate is
initialized to the value stored in the set-
tings file on start up.
Factory setting is displayed here and may
be edited via the web interface
Discard changes and return to
previous screen
Select from the pull-down menus
Modem menu/window may appear
different for systems equipped with
a CXCI
Accept changes and return to
previous screen
Figure 109 — Point to Point Protocol Connection Device
6.9.4 Web Settings
The Supervisor can set the port routing for the CXC web interface (accessed via PPP for modem).
6.9.5 Master SNMP Destination (Web Interface Only)
See 10.3.3.1.
6.9.6 SNMP Multiple Community Names (Web Interface Only)
See 10.3.1.
6.9.7 Event Notification Destination (Web Interface Only)
See 10.3.3.
Discard changes and return to
previous screen
Select from the pull-down menu
Accept changes and return to
previous screen
Figure 110 — Web Settings window
Web Interface